So I managed to set up Timer0. I can see that the timer counts. What I would need/expected is that I could see the square sign on pin 4 (since pin for is attached to timer0). But it doesn't seem to happen. Do I have to enable that timer0 is connected to pin 4? int timer=0; void setup() { pinMode…

Thanks for the help I finnaly found it: in TCCRnA setting (COMnB0) and (COMnB1) where n is the number of timer you use, enables a toggle on a match: int timer=0; void setup() { pinMode(2, OUTPUT); TCCR3A=0; TCCR3B=0; TCCR3B=(1<<WGM32); OCR3A=23; TIMSK3|=(1<<OCIE3A); sei(); //Enable interru…

Arduino Mega enable pin connected to timers

Other Hardware 3rd Party Boards

Whandall October 24, 2021, 5:13pm 5

All the sketches I have seen, were not able to show anything on pin 4.

Topic		Replies	Views
How to use timers inside arduino? Syntax & Programs	13	22937	May 6, 2021
can't see timer output on pin Programming	1	671	May 5, 2021
Timer interrupt Syntax & Programs	21	19474	May 6, 2021
Programming the hardware timers - advanced level Programming	10	6002	May 5, 2021
Timer0 pin6/OC0a & pin5/OC0B question... Troubleshooting	4	6107	May 6, 2021

Arduino Mega enable pin connected to timers

Related topics