Arduino nano iot33 fix sample rate?

[New-to-codin]

Please how do I adjust theAccelerometer sample rate

/*
  Arduino LSM6DS3 - Simple Accelerometer

  This example reads the acceleration values from the LSM6DS3
  sensor and continuously prints them to the Serial Monitor
  or Serial Plotter.

  The circuit:
  - Arduino Uno WiFi Rev 2 or Arduino Nano 33 IoT

  created 10 Jul 2019
  by Riccardo Rizzo

  This example code is in the public domain.
*/

#include <Arduino_LSM6DS3.h>

void setup() {
  Serial.begin(9600);
  while (!Serial);

  if (!IMU.begin()) {
    Serial.println("Failed to initialize IMU!");

    while (1);
  }

  Serial.print("Accelerometer sample rate = ");
  Serial.print(IMU.accelerationSampleRate());
  Serial.println(" Hz");
  Serial.println();
  Serial.println("Acceleration in G's");
  Serial.println("X\tY\tZ");
}

void loop() {
  float x, y, z;

  if (IMU.accelerationAvailable()) {
    IMU.readAcceleration(x, y, z);

    Serial.print(x);
    Serial.print('\t');
    Serial.print(y);
    Serial.print('\t');
    Serial.println(z);
  }
}

[sterretje]

@New-to-codin, your topic has been moved to a more suitable location on the forum. Installation and Troubleshooting is not for problems with (nor for advise on) your project See About the IDE 1.x category.

@New-to-codin

We saw a link to using Sparkfun library, calling the function was a problem.

Please describe the problem; if you get errors during compile or upload, post them here (using code tags).

I'm not familiar with your board so can't be of much assistance.

[sterretje]

If your board is a classic Nano, please change the title of the topic.