Arduino Nano RP2040 Connect No Port

Official Hardware Nano Family Nano RP2040 Connect
1

This error has happened on 2 of my Arduino Nano RP2040 Connect so far, which leads me to believe there is something up with my computer. Basically, programs are very slow to upload (upwards of 10 minutes) and then they will always fail without any error message besides "Exit status 1" even with verbose language. I've tried it on IDE 1.8.19 and 2.0, but after a while of this failure to upload, the board simply doesn't show up in my ports anymore.

It happens with a lot of different solutions and all programs can compile perfectly fine before uploading. The only program I could even get on this 2nd Arduino before the port disappeared was Blink. Also Arduino happens with multiple different cables and USB ports too.

Does anyone know what could be wrong? I'm not the most experienced but I've used other Arduino before without this error. Let me know if there's any information I need to provide to help.

2

Welcome to the forum.
Which Operating System do you use ?

3

Hello, I use Windows

4

Which version ?

5

Windows 10, up to date i believe

6

Take a look at https://support.arduino.cc/hc/en-us/articles/4404168794514-Nano-RP2040-Connect-not-being-detected-on-USB-port

7

This actually worked, Thank you, I had to factory reset it several times but after a few it worked

8

Alright, please mark the suggestion that resolved the issue as a "solution" to help others who have similar issue.

9

This topic was automatically closed 180 days after the last reply. New replies are no longer allowed.