Arduino Pro Mini Schematic RESET poles

Development Tools Uploading
1

In the Arduino Pro Mini schematic

Where exactly are the RESET poles going to from the 10 pin headers in the schematic.

I bought a ATmega328P surface mount chip to breadboard adapter and have breadboarded the entire Arduino Pro Mini’s schematic with through-hope components(minus the voltage regulator). I unfortunately am failing to burn the bootloader to the ATmega328P chip in this breadboarded circuit. I having no problem when burning the bootloader to the original off the shelf Arduino Pro Mini board though. Since I have mirrored the set-up for burning the bootloader I assume my breadboarded Arduino Pro Mini schematic is incorrect. Maybe it’s that RESET pin.

2

Moved your topic to it's current location / section as it is more suitable.

Could you take a few moments to Learn How To Use The Forum.
Other general help and troubleshooting advice can be found here.
It will help you get the best out of the forum in the future.

3

Genifis:
In the Arduino Pro Mini schematic

https://www.arduino.cc/en/uploads/Main/Arduino-Pro-Mini-schematic.pdf

Where exactly are the RESET poles going to from the 10 pin headers in the schematic.

To the reset pin on MCU, it is U1 pin 29.