Arduino Severino s3v3 problem with atmega8


I make arduino severino board based on site instructions, burned bootloader for atmega8 from arduino/hardware/arduino/bootloader/atmega8/ATmegaBOOT.hex with avrdude under Linux:

avrdude -p m8 -c stk200 -P /dev/parport0 -U flash:w:ATmegaBOOT.hex

After that i write fuse bits:

avrdude -p m8 -c stk200 -P /dev/parport0 -U lfuse:w:0xff:m -U hfuse:w:0xca:m

LED 4 (power) is “on” after i give power to arduino board, led L (LED 3) is blinking with ~10 seconds interval.

But i can’t write sketches to arduino board with Arduino IDE (ver 1.0 latest): even when i choose any example sketch, when i push “Verify” button i have following errors:

/usr/share/arduino/hardware/arduino/cores/arduino/HardwareSerial.cpp:93:11: error: attempt to use poisoned "SIG_UART_RECV"
/usr/share/arduino/hardware/arduino/cores/arduino/HardwareSerial.cpp:94:4: error: #error "Don’t know what the Data Received vector is called for the first UART"

I use Arch Linux and following package versions:

Arduino IDE arduino 1:1.0-3 compiled from this package:

avr-gcc 4.6.3-1 gcc 4.7.0-3 (base-devel) gcc-libs 4.7.0-3 (base) lib32-gcc-libs 4.7.0-3

My system is x86_64

I will provide any other info on your request to debug this problem