Hey, I build an Breadboard as Prototype for an LED Controler (controlls 2 different RGB Strips). The Arduino controls 6 Transistors, each leads to 1 GND Pin of one LED-Strip. All worked fine, I created the PCB on PC an though before I make one, I test the circuit again. And now I sometimes have to…

Problem found. I made it possible to read 2 RGB Values. Since I sometimes only send 1, it goes in Timeout with 3 values => 3s. Now I send CommandID 1/2 (depending on amount) and check the amount of RGB Values => almost instant answer. Changing that for the other Commands

Arduino UNO + HC05 => Code runs with Delay / slow

Other Hardware LEDs and Multiplexing

rpgfabi September 9, 2021, 4:01am 3

Sounds good, gonna test that. But what can happen if you set it too low?
Does it then fail to read longer data?

Topic		Replies	Views
Delay with hc-05 communication Programming	12	5058	May 6, 2021
Bluetooth und Arduino UNO Deutsch	14	1043	May 6, 2021
[ RISOLTO ]Settare PWM da SerialMonitor + Bluetooth Software	49	13317	May 7, 2021
Bluetooth HC-05 command delay 3rd Party Boards	37	6624	April 24, 2022
Ayuda con Arduino uno y delay Español	15	6703	May 6, 2021

Arduino UNO + HC05 => Code runs with Delay / slow

Related topics