Arduino with Xbee series 2.

Hi All,

I am trying to communicate with my Arduino wireless using Xbee Series 2(XB24-B). My system consists of an Arduino R3, an Ethernet Shield and an Xbee shield. I am using the XCT-U to set up the Xbee but so far without any luck. I have followed several examples but still nothing.

My configuration is the following: Coordinator: XB24-B and ZNET 2.5 COORDINATOR AT PAN ID ---> 1234 DH ----> 13A200 DL ----> the SL from ROUTER/END Xbee SH ----> 13A200 SL ----> the DL from ROUTER/END Xbee

Router/End Device: XB24-B and ZNET 2.5 ROUTER/END DEVICE AT PAN ID ---> 1234 DH ----> 13A200 DL ----> the SL from COORDINATOR Xbee SH ----> 13A200 SL ----> the DL from other COORDINATOR Xbee

Do you think that causes any problem using Arduino with Ethernet shield and Xbee shield ? Does anyone know what are the settings to communicate the Xbee Series 2 modules?

Many Thanks!

Do you think that causes any problem using Arduino with Ethernet shield and Xbee shield ?

You could always remove the Ethernet shield, until the XBees are talking, to eliminate that possibility.

I am using the XCT-U to set up the Xbee

With what hardware?

Thank you PaulS for your reply.

I have remove the Ethernet shield but still the same.

With what hardware?

I am using an Xbee Explorer Dongle to configure the Xbee antenna's if I understand correctly your question.

How do you set SH and SL to the value of the other module? It’s read-only and must be the own address of the module.