AT commands for GPRS configuration and HTTP GET

Official Hardware Retired GSM Shield
1

Hello,
does anyone have AT command for GSM shield to connect to GPRS, and then send HTTP GET request? I am using M10 Arduino GSM shield with AT90CAN128 and I'm trying to send some data from my at90 to my PC. Or maybe AT commands for connecting by TCP/UDP to tcp server on PC? What is better or simplier?
Few days ago I found pdf with M10 AT commands, but I think I'm using them wrong :frowning:
However I managed to send SMS from my device after 10 minutes...

Please, does anyone have working commands for http get request?
A would appreciate for you help very very VERY! much.
Best regards

2

OK, i solved my problem. You can delete this post, or leave it for other users. If you want to use HTTP GET request, use:

AT+QIFGCNT=0\x0D

AT+QICSGP=1,"XXX"\x0D - where XXX is your APN

AT+QIREGAPP\x0D

AT+QIACT\x0D

AT+QHTTPURL=AA,BB\x0D - where AA is length of http address, and BB is time in seconds to enter the address

AT+QIDEACT\x0D