So, I've got a brand new 328P-PU running on a mini breadboard. I've successfully burnt the 16Mhz Arduino bootloader and I've managed to upload the Blink sketch fine by doing the manual reset. I'm using a Prolific PL2303 based USB>Serial board and it has only 3v3, Vcc, RX, TX, Gnd connections. On an…

ATMega 328P-PU on Breadboard with PL2303 USB>Serial

CrossRoads December 17, 2012, 12:13am 4

Use some flux, don't overdo it with solder. Good luck!

Topic		Replies	Views
A USB cable with auto-reset for less than 4 $ IDE 1.x	14	15179	May 5, 2021
PL2303 USB/Serial per Programmare 328P ma ricevo errori RISOLTO!!! Generale	17	6861	May 7, 2021
Arduino Serial Board 3rd Party Boards	11	6384	May 6, 2021
Arduino on breadboard problems Troubleshooting	31	13231	May 6, 2021
Arduino breadboard with CP2102 module Troubleshooting	3	2297	May 6, 2021