I am using the Attiny85 programmed in the Arduino IDE. I was able to activate the internal pull-up resistors on pins 1 and 3, and the voltage I measured on them was close to the supply voltage of 5V. However, when I activate the internal pull-up on pin 0 with pinMode(0, INPUT); digitalWrite(0, HI…

Attiny85 using Arduino IDE, pull-up resistor voltage is too low

smithy April 25, 2014, 10:10pm 7

Try another chip.

Topic		Replies	Views
ATtiny84 with internal pull-ups 3rd Party Boards	17	6609	May 6, 2021
ATtiny85 pullup resistor issue 3rd Party Boards	5	2440	May 6, 2021
Can't measure voltage with Attiny85, need help Programming	9	5610	May 5, 2021
ATTINY85 reference voltage 3rd Party Boards	4	1946	May 6, 2021
Programming ATTiny with Arudino (Hi Low Tech) Enabling Internal Pullup Resistors 3rd Party Boards	5	9600	May 6, 2021