AVRDUDE download to Arduino Uno not possible stk500v2:ReceiveMessage()timeout

Development Tools IDE 1.x
1

I want to download a hex file to my arduno uno board with the avrdude programm.
I was not able to find any answer within the tons of post in the forum.

The output in the terminal shows that the PC can't esthablish the communication with the FTDI programmer. The output is stkv2_recaiveMessage()timeout.

Facts:

  1. programming the board with the AVR IDE works perfect. But it wont work with avrdude
  2. I have added a reset button from pin 1 of the Atmega328P to GND to manually invoke the reset signal if needed
  3. I'm using the FTDI Adapter. I don't know which FW version is on it but within the command line of avrdude i tried both versions (v1 and v2)
  4. The avrdude.conf file resides in the same directory as avrdude.exe
  5. I'm using Windows 7 64Bit
  6. The FDTI is dedected at COM Port 4
  7. I double checked the CPU model which is a Atmega328P -> so I'm using the m328p parameter
  8. The command is as follows:

avrdude -c stk500v2 -P\.\COM4 -p -v -F -D -Uflash:w:"test.hex":i

Please see the output within the terminal in the attachment

does anybody has an Idea what's wrong?

Error.txt (8.47 KB)

2

I've now replaced the FTDI interface with an USBTinyISP.
I connected the target to the USBTiny.

Probably the bootloader is defect, therefore I want to burn the bootloader with avrdude because arduino IDE does not work. The output shows that USBTiny can flash the ATmega328p but it fails during verify.

So I tried this command over the terminal:

avrdude -c usbtiny -p m328p -e -U flash:w:ATmegaBOOT.hex
please see attachment the corresponding output.

I doubt that there is a fuse problem. I read to be carefully with writing the fuses. So I did not overwrite the fuses.

Please can you help?
Thanks

arduino IDE output.txt (3.61 KB)

arduino IDE output.txt (3.61 KB)