I broke something and I've run out of ideas as to what it may be...
I've built a custom board with an arduino (socketed thankfully), an lcd, etc.
Everything was just fine until I cooked a little 5k trimmer. I replaced it and started getting the out of sync message.
So I was thinking that when I shorted the trimmer, I must've damaged the chip. No problem, had a spare, popped it in,, same thing, out of sync error.
Hmm, ok, popped the chip into a BBB and using the same cable/computer, I can upload to both chips without problem.
So, the problem is with my board, but I can't find anything wrong with it and if I upload the program on the BBB and then place that chip in the board in question, the program runs just fine.
Anyone have any suggestions as to what I should look for?
Thanks,
Chris