Avrdude: ser_open(): can't set com-state for "\\.\COM5" - Possible solution

Development Tools Uploading
7

Open IDE and attempt to upload sketch

avrdude: Version 6.3-20190619
Copyright (c) 2000-2005 Brian Dean, http://www.bdmicro.com/
Copyright (c) 2007-2014 Joerg Wunsch

     System wide configuration file is "C:\Users\admin\AppData\Local\Arduino15\packages\arduino\tools\avrdude\6.3.0-arduino17/etc/avrdude.conf"

     Using Port                    : COM5
     Using Programmer              : arduino
     Overriding Baud Rate          : 57600

avrdude: ser_open(): can't set com-state for "\.\COM5"

avrdude done. Thank you.

Failed uploading: uploading error: exit status 1

Open and close plotter

avrdude: AVR device initialized and ready to accept instructions

Reading | ################################################## | 100% 0.00s

avrdude: Device signature = 0x1e950f (probably m328p)
avrdude: reading input file "C:\Users\admin\AppData\Local\arduino\sketches\83772851F47F36FAA74A5C34FD29D3A4/HallTest.ino.hex"
avrdude: writing flash (1062 bytes):

Writing | ################################################## | 100% 0.35s

avrdude: 1062 bytes of flash written

avrdude done. Thank you.