Ayuda: Arduino Due y Acelerometro MMA7361

Programe mi placa Arduino Due con el Acelerometro MMA7361 con el siguiente codigo:

const unsigned X_AXIS_PIN = 0;
const unsigned Y_AXIS_PIN = 2;
const unsigned Z_AXIS_PIN = 4;
void setup() {
** Serial.begin(9600);**
}
void loop() {
** Serial.print(analogRead(X_AXIS_PIN));**
** Serial.print(" ");**
** Serial.print(analogRead(Y_AXIS_PIN));**
** Serial.print(" ");**
** Serial.println(analogRead(Z_AXIS_PIN));**
** delay(100);**
}

Al usarlo el programing port me devuelve esto:

Sketch uses 11.028 bytes (2%) of program storage space. Maximum is 524.288 bytes.
No device found on COM5

y al usarlo en el native port:

Erase flash
Write 12172 bytes to flash
[ ] 0% (0/48 pages)
[====== ] 20% (10/48 pages)
[============ ] 41% (20/48 pages)
[================== ] 62% (30/48 pages)
[========================= ] 83% (40/48 pages)
[==============================] 100% (48/48 pages)
Verify 12172 bytes of flash
[ ] 0% (0/48 pages)
[====== ] 20% (10/48 pages)
[============ ] 41% (20/48 pages)
[================== ] 62% (30/48 pages)
[========================= ] 83% (40/48 pages)
[==============================] 100% (48/48 pages)
Verify successful
Set boot flash true
CPU reset.

Alguna sugerencia?

Si, que tienes mal asignado el puerto de programación

Acá te muestro en el IDE que debes mirar