Hello,
have bought this motor and can't get it running, it's just oscilating around zero position.
Have used the same code as for A2212 motor.Can't find anything helpfull on internet.
Please, advise.
Thank you.
Branko
Probably line 20 of your code.
That might not be right. My crystal ball has been acting up lately.
I think you have the red and purple wires crossed. If swapping them does not help post your annotated schematic (the language of electronics) and your code.
For the A2212 motor I use <servo.h> library, and timing between 1000 and 2000 microseconds.
If somebody has been using or does use the 2515 motor, can, please give data for the control signal ?