OK edit to post, I just blew my USB/card reader up with a lil feedback (good times I thought it was the arduino that had broke!). Here is my setup (as soon as I get the images uploaded). I really need help on this I only have one set of USB hubs left before my MOBO gets it ]:D.
Yellow = direction pin 4
Blue= step pin 7
balck and red = -ve/+ve (into case = +5v VDD and GND) (exterior VMOT and GND attatched to 11v output on pc supply)
Grey = enable pin 2
no ms pins connected.
O and the blob of solder next to the blue is shorting the reset pin to the sleep pin.
The four wires I am holding are to the motor and have been paired.
best source so far, but i think after modding it blew my usb hub up Welcome cerebralmeltdown.com - BlueHost.com