great! thanks for the help!
then I'll get myself an "uno"!
however if you're running the Arduino from 12v then use the same PSU for the servo.
even if it's running on higher current? what will happen if the motor
will consume a lot of current in a peak? i assume the arduino has its protection but is it harmless for it in the long run?
you'll have to come up with a protocol and implement some hysteresis in the control loop.
does that mean like a protocol which i will program myself?
or a premade, lower-level one? and if so could you recommend me of one? or just give me a direction..
Thanks again!
Roy. 