Hello, I want to pre-program the u-chip and transfer it to a much smaller, less complicated board, for use. To supply the 16 MHz to the u-chip, normally you'd get a 2 pin crystal resonator and stick it between pins 8 and 9 (on the u-chip im using) with 2 caps to ground. However, i have a fully pack…

Can I use a 4 pin oscillator instead of a 2 pin crystal when running off board?

Topic		Replies	Views
Using Oscillator as a Crystal General Electronics	9	2607	May 6, 2021
ATmega168 standalone w/ oscillator Frequently-Asked Questions	4	1526	May 6, 2021
change of external crystal to internal Frequently-Asked Questions	12	4764	May 6, 2021
Oscillator for arduino standalone General Electronics	22	5742	May 6, 2021
from 16mhz to 8mhz Frequently-Asked Questions	2	1086	May 6, 2021