can rs485 shield and loRa shield be stacke on arduino?

I need my Arduino to be integrated with my rs485 shield to get sensors reading using MODBUS protocol and use my Arduino as loRa node to send those readings to my Raspberry pi gateway. So my question is , can I stack those loRa shield and Rs485 shield on Arduino ?

Don't cross post. Find the circuit diagrams for the two shield and check to see if they are using the same pins.

Other thread removed.

you can stack the shields but have to avoid conflicts e.g. if the Lora pin mapping is

// Pin mapping  for Dragino LoRa Shield 
const lmic_pinmap lmic_pins = {
    .nss = 10,
    .rxtx = LMIC_UNUSED_PIN,
    .rst = 9,
    .dio = {2, 6, 7},
};

and the RS485 shield also uses pin 10 you could stack the RS485 on the Arduino and then the Lora shield having cut or bent pin 10 on the Lora shield so it does not connect thru to the RS485 shield then put a jumper between pin 10 on the Lora shiled to a spare pin - update the Lora shield pin mapping accordingly