Can SD library work with Logomatic v2?

Hi everyone

I have a quick question. I am trying to use the SD library to write a file in an SD card by using an Arduino Uno and a Logomatic V2 (sparkfun), by following the commands as specified in http://arduino.cc/en/Tutorial/ReadWrite (e.g.: custom file name, etc etc).

After some experimentation, so far I have been able to have the logger to record whatever goes out through the serial output into files that follow the "LOG0XX.TXT" format (as specified in the datasheet). In this case, what I did was to connect the following:

Logomatic -------> Arduino
RX01 -------------> TX (pin 1)
GRD --------------> GRD
BATT -------------> 3.3v

HOWEVER... what I would like to do is for the arduino to record the information as described in the ReadWrite tutorial above.

I have a feeling that the problem is in the actual wiring. Anyone has any suggestions on which pin(s) have to go between the Arduino and the logomatic?

Here is some info on the logomatic (schematics, etc): https://www.sparkfun.com/products/10216

Any thoughts and/or experiences? :slight_smile:

HOWEVER... what I would like to do is for the arduino to record the information as described in the ReadWrite tutorial above.

OK. What's stopping you?