Hi friends, I have a problem with getting voltge readout from analog pins in Arduino Uno. I have two TCST1103 sensors connected to those inputs (A3 and A4). Their behaviour is simple and can be checked by measuring a voltage on 100 ohm grounded resistor. Of course that GND is connected to arduino's…

[image] jwut: pinMode(A3, INPUT_PULLUP); // sensor 0 The following diagram (Fig-1) will help you to understand that it is not possible (and also not needed) to connect internal-pull-up resistor (Rip) when using A3-line (A4) as an analog channel for the internal ADC. Moreover, while executing…

Cant get 2 analog input readouts correctly

Other Hardware Sensors

anon73444976 October 5, 2021, 8:55pm 7

In this way

if(*which_sensor==1){

Topic		Replies	Views
analogRead help needed Troubleshooting	14	4711	May 6, 2021
Mutliple inputs Troubleshooting	29	5233	May 6, 2021
strange analog input? Wierd... Troubleshooting	25	14435	May 6, 2021
Analog inputs linked somehow? Sensors	13	6067	May 6, 2021
Problema con analogRead Software	25	10899	May 7, 2021

Cant get 2 analog input readouts correctly

Related topics