Change pins in Wire library

Hi, I'd like to use an MLX90614 temperature sensor (http://www.sparkfun.com/products/9570) with Lilypad. I would like to work with I2C protocol to have a better precision and the example on Sparkfun (http://bildr.org/2011/02/mlx90614-arduino/) uses the I2CMaster library, which uses the Wire library in turn. The problem is that the Wire must use the analog pin 4 and 5, not easily accessible on the Lilypad. Is it possible to change the pins used by Wire library for I2C communication?

Thanks in advance.

Matteo

No these pins are using features that are hard wired into the arduino's configuration it is not easy to change them.

Thank you for your reply. I will necessarily use the analog pins 4 and 5.

Bye,

Matteo