I have multiple I2C anemometers that I'd like to read data from, but they all have the same base address. It is possible to change the addresses, but the data sheet doesn't make it super clear for how to do it using Arduino. I've attached the relevant pages and the code the sensor supplier provided …

The I2C address is not 0xC0. Can you run a I2C Scanner sketch ? It should be 0x60. There are a few more things in the datasheet that are misleading or incomplete. When data is read via the I2C bus, I think a repeated start should be used. Could you try this: Wire.beginTransmission( 0x60); int e…

Changing I2C Address of Sensors

Other Hardware Sensors

ngroberts15 October 1, 2021, 12:59pm 5

This code combined with @johnwasser did solve my problem, thank you!

Topic		Replies	Views
How to deal with multiple I2C sensors with the same address by one Arduino? Networking, Protocols, and Devices	3	3968	May 6, 2021
i2c addresses Programming	6	3238	May 5, 2021
Wiring up an i2c Bus Networking, Protocols, and Devices	7	1792	May 6, 2021
I2C question Networking, Protocols, and Devices	31	12179	May 6, 2021
About Sharing of I2C interface Sensors	14	4700	May 6, 2021

Changing I2C Address of Sensors

Related topics