Oh I can? Then I need to figure it out. I'm still figuring out a diagram before I do final connections. As fa as connections go the lily has ( 4 digital, 6 digital pwm ,1thx,1rx, 4 anologs and 2 power) the led display has (16 pins with 4 more for com) my. My problem is I'm not sure how to connect them properly, I was more on hoping the resistance from the flex sensor to direct the led display.
I need to Take the same signal from the sensor and translate it into 2 set of commands, one is for the flex sensor to move the servo and the second is for the flex sensor to led display. I was thinking using the level of resistance and map that out to the led display.
The led display is going to be my visual warning of how much throttle I'm using no mater what position my servo is in. So I need It to light up each led as the throttle increases.
Ps. I appoligise now if I'm not making any sense, I'm just getting in to this and I'm still learning. Thnx for the input