Hello, I wrote this code and it does what I want but it will stop working after some hours. I need this code to run as long as needed. It is to raise and lower sharpies onto 3D printing filament at different intervals. I gather it is from the use of Delay instead of millis, but I dont know enough…

Code stops after some time using delay

cattledog October 1, 2021, 11:24pm 5

Does it stall out equally in all 4 cases? Can any one case run longer than the others?

How are the Servos powered?

Topic		Replies	Views
Need guidance on Timer/Delay Problems. Programming	29	9102	May 5, 2021
how to use millis instead of delay? Syntax & Programs	14	22719	May 6, 2021
millis() as delay() General Guidance	18	7187	May 5, 2021
Servos Delay Robotics	21	26528	May 6, 2021
delay() Troubleshooting	12	3484	May 6, 2021