(Wasn't completely sure which category to put it in) (this isn't any question or anything, just sharing the code i used, might not be the right place to share it tho, not sure.) Code for controlling multiple servo motors with pca board and remotely control the servos through the serial monitor in …

That code will not work as described. D0 and D1 are used to communicate with the IDE, on an UNO. Use other pins for the first to servos.

On an UNO D0 and D1 are used by the USB interface. No servo will work well connected to them.

If the matrix of pins 0, 1, .... referes to the PCA 9685 pins it's another story.

[image] Railroader: pins 0, 1, .... referes to the PCA 9685 pins yup

Code to control multiple servos with pca9685

zusi December 7, 2023, 2:48pm 3

thanks for the feedback but i didn't understand any of it tbh, no offence and disrespect. It worked just fine for me, without any issue

Topic		Replies	Views
Slow PCA9685 Servo project General Guidance	21	191	April 29, 2026
Help control servos with PCA9685 Programming	8	1410	February 26, 2020
Muovere dei servo con la scheda PCA9685 Hardware	1	173	July 19, 2024
New user trying to program Uno for plane controls Programming	14	210	May 23, 2026
Issues with PCA9685 and Servos (Arduino Uno) General Guidance	7	2832	June 2, 2022