Communication between PLC and Arduino/Galileo/Raspberry using EtherNet/IP

Hello,

I need to send data to a PLC from an Arduino or Intel Galileo or Raspberry or another...
Using the protocol EtherNet/IP (Industrial Protocol, not Internet Protocol).

Somebody already done it? You know if this is possible? Any help will be welcome :slight_smile:

While I may be a newbie to the Arduino arena, not new to the challenges of PLC comes to "other"devices.

I have used some for comma with our Linix systems and work well. This may be a good starting point for your project.

Best bet:
https://eipnet.codeplex.com

Other options:

Bridges:
http://www.anybus.com/products/ethernetip.shtml

Good luck!!

ortizvinicius:
Using the protocol EtherNet/IP (Industrial Protocol, not Internet Protocol).

Isn't Ethernet/IP a "proprietary" protocol develop by Allen Bradley?