Compass CMPS11 do not work with Arduino M0 pro I2C bus

Compass CMPS11 do not work with Arduino M0 pro I2C bus.
Work perfect with Arduino uno. please help

Do you use a level converter? The M0 runs on 3V3, not 5V.

Post a wiring diagram!

I do not use a level converter. is that a special unit?
I have just connected liftup resistors 1.8 k to 5V. Did not work.
I also tried liftup resitors to 3.3 V- Did not wor either.
The CMPS11 should work with 3.3 Vollt and 5 Volt signal level according to specifications.
What si wrong here?

Each device would have four ways to connect to each other via four different sockets (s1 ... s4), aways using up to 2 pins.

That might have fried your M0 pins.

The CMPS11 should work with 3.3 Vollt and 5 Volt signal level according to specifications.

In the specification I found it simply says that the Vcc pins accepts 3.6V to 5V. What voltage did you apply to that pin? If it's 5V as on the UNO, you need a level converter, that's a circuit that translates between the 3V3 of the M0 and the 5V the module uses.