Ok,
That's the sketch:
/*
SMS sender
This sketch, for the Arduino GSM shield,sends an SMS message
you enter in the serial monitor. Connect your Arduino with the
GSM shield and SIM card, open the serial monitor, and wait for
the "READY" message to appear in the monitor. Next, type a
message to send and press "return". Make sure the serial
monitor is set to send a newline when you press return.
Circuit:
* GSM shield
* SIM card that can send SMS
created 25 Feb 2012
by Tom Igoe
This example is in the public domain.
http://arduino.cc/en/Tutorial/GSMExamplesSendSMS
*/
// Include the GSM library
#include <GSM.h>
#define PINNUMBER ""
// initialize the library instance
GSM gsmAccess;
GSM_SMS sms;
void setup()
{
** // initialize serial communications and wait for port to open:**
** Serial.begin(9600);**
** while (!Serial) {**
** ; // wait for serial port to connect. Needed for Leonardo only**
** }**
** Serial.println("SMS Messages Sender");**
** // connection state**
** boolean notConnected = true;**
** // Start GSM shield**
** // If your SIM has PIN, pass it as a parameter of begin() in quotes**
** while(notConnected)**
** {**
** if(gsmAccess.begin(PINNUMBER)==GSM_READY)**
** notConnected = false;**
** else**
** {**
** Serial.println("Not connected");**
** delay(1000);**
** }**
** }**
** Serial.println("GSM initialized");**
}
void loop()
{
** Serial.print("Enter a mobile number: ");**
** char remoteNum[20]; // telephone number to send sms**
** readSerial(remoteNum);**
** Serial.println(remoteNum);**
** // sms text**
** Serial.print("Now, enter SMS content: ");**
** char txtMsg[200];**
** readSerial(txtMsg);**
** Serial.println("SENDING");**
** Serial.println();**
** Serial.println("Message:");**
** Serial.println(txtMsg);**
** // send the message**
** sms.beginSMS(remoteNum);**
** sms.print(txtMsg);**
** sms.endSMS();**
** Serial.println("\nCOMPLETE!\n");**
}
/*
** Read input serial**
*/
int readSerial(char result[])
{
** int i = 0;**
** while(1)**
** {**
** while (Serial.available() > 0)**
** {**
** char inChar = Serial.read();**
** if (inChar == '\n')**
** {**
__ result = '\0';__
* Serial.flush();*
* return 0;*
* }*
* if(inChar!='\r')*
* {*
_ result = inChar;
* i++;
}
}
}
}[/b]
(as the story is too long and I exceeded the max.message length, I post the Error in the next post)*_