The Neon/Argon calibration lamp box is complete and operates with mouse-clicks using Firmata_Test and Arduino Uno. The calibration lamp progress is at the bottom of the page; Custom Spectrogaph - Seite 2 - Forum der Vereinigung der Sternfreunde. The lamps are now computer-controlled using Firmata_Test. So, too, will be the other motors as I progress into laying out the optical parts to motorize. The device could be 14 feet in the air when in use hence my making it remote controlled. The motors to do operations will also be tied to other pins of Arduino. The problem is Firmata_Test Original does not remember input/output configurations that I'd set so those, right now, always need to be reconfigured when I restart it, but if the code were changed and re-compiled it would be awesome....
I have attached a picture which shows three panes of Firmata; (left)Original Firmata_Test, (center)Modified to show what the names of the pins should be, the new dedicated input or output (not needing selectable anymore), and, the two states the input or output should read (not High/Low anymore), and, (right)What the end file would look like (what I'd like it to look like) when each line is showing one state like it would in operation.
Is this possible?
Thanks for considering it.
Best,
Steven
