connect 28byj-48 to motor drive shield

Hi!

Im been googeling alot on how to connect a step motor 28byj-48 to the connector on the motor driver shield.I can not find place that show how to.
I will be using the 5-pin header on the right.
the color os the wires on the step motor are:
blue
pink
yellow
orange
red

the shematic of the shield is this:

sorry forgot to add the datasheet for the step motor.
http://www.sensors.co.nz/datasheet/28BYJ-48%20Stepper%20Motor.pdf

Connect pink and red orange wires to one pair of motor outputs (e.g. M1A and M1B, either way round), and yellow and blue to the other pair. Leave the red wire unconnected.

btw that is a unipolar stepper motor so it doesn't actually need a motor driver, you can use something simpler like a ULN2803 to drive it.