Connect more than 2 Servos with Adafruit motor shield v2

Using Arduino Motors, Mechanics, Power and CNC
#1

Hi everybody,

I was wondering if it is possible to connect more than 2 servos to arduino due with Adafruit motor shield. I have been looking long without success on internet, and I am starting thinking that this is impossible! Many thanks in advance for your replies :slight_smile:

#2

Motor shield does not drive servos, you only need a control signal for a servo.

Connect to Arduino Gnd and power from a separate supply, the small regulator on the Arduino board is overwhelmed by the power draw of most servos.

#3