Hi, how do I go about soldering the following DC Power Jack . Tabs 4 & 5 are shield and beep when continuity checked, so no need to create a track between them or should I create the track? Should Tab 4 be connected with track to tab 3 or 2? to make the most of it? and also connect to Arduino GND …

Put large pads for 4 & 5 and connect them to the ground plane on the PCB. The pads should be large so that they can take more solder and make a mechanically strong bond between the socket and the PCB. For your other questions, it depends on how the plug is wired. Will it be centre positive? If so, …

Connecting DC Power Jack

Other Hardware General Electronics

PaulRB October 2, 2021, 1:20pm 5

You should fix that.

1 Like

Topic		Replies	Views
Powering the board with a DC Barrel Jack adapter General Guidance	2	1553	May 5, 2021
Arduino DC Power Jack Development	5	3973	May 6, 2021
PCB Grounding and Power Tracking Questions General Electronics	6	3955	May 6, 2021
Is the GND pin required ? General Electronics	6	1927	May 6, 2021
New Female DC power adapter does not work (has screw block terminals) General Electronics	15	5745	May 6, 2021

Connecting DC Power Jack

Related topics