Connecting MPU6050

Hey there!
I want to get the Gyro raw values and temperature with the MPU 6050 Module and an Arduino Nano.

My code :

#include<Wire.h>
const int MPU_addr=0x68;  // I2C address of the MPU-6050
int16_t Tmp,GyX,GyY,GyZ;
void setup(){
  Wire.begin();
  Wire.beginTransmission(MPU_addr);
  Wire.write(0x6B);  // PWR_MGMT_1 register
  Wire.write(0);     // set to zero (wakes up the MPU-6050)
  Wire.endTransmission(true);
  Serial.begin(9600);
}
void loop(){
  Wire.beginTransmission(MPU_addr);
  Wire.write(0x3B);  // starting with register 0x3B (ACCEL_XOUT_H)
  Wire.endTransmission(false);
  Wire.requestFrom(MPU_addr,14,true);  // request a total of 14 registers
  Tmp=Wire.read()<<8|Wire.read();  // 0x41 (TEMP_OUT_H) & 0x42 (TEMP_OUT_L)
  GyX=Wire.read()<<8|Wire.read();  // 0x43 (GYRO_XOUT_H) & 0x44 (GYRO_XOUT_L)
  GyY=Wire.read()<<8|Wire.read();  // 0x45 (GYRO_YOUT_H) & 0x46 (GYRO_YOUT_L)
  GyZ=Wire.read()<<8|Wire.read();  // 0x47 (GYRO_ZOUT_H) & 0x48 (GYRO_ZOUT_L)
  Serial.print("Tmp = "); Serial.print(Tmp/340.00+36.53);  //equation for temperature in degrees C from datasheet
  Serial.print("GyX = " + GyX);
  Serial.print("GyY = "); Serial.print(GyY);
  Serial.print("GyZ = "); Serial.println(GyZ);
  delay(333);
}

My question is how I have to wire it up with my nano.
I know that…
MPU Nano
…Gnd => Gnd
…Vcc => 3.3V
…Ado => Gnd

But whats with the other pins?

Thanks for any answer

SDA Pin A4
SCL Pin A5

Google for "arduino nano pinout"
see Arduino Playground - MPU-6050

Thanks man!