Hello, I wondered if there was an eagle cad expert out there that can help me understand this problem. please forgive me I am new to designing parts in eagle and I dont think I drew the relay symbol and capacitors correctly but the pins should be labeled properly. Project: I am hand etching my own …

Connecting parts to a ground plane in eagle

system April 28, 2014, 5:38pm 15

thanks... how do you clean off the flux?

Topic		Replies	Views
Why won't Eagle route this airwire? General Electronics	10	7635	May 6, 2021
Eagle ground fill question General Electronics	7	4704	May 6, 2021
[HELP] Eagle e tracce GND Generale	17	5742	May 7, 2021
Arduino Diecimila gridded ground plane + EMC Development	11	4670	May 6, 2021
Bad ground pour on PCB Hardware Development	9	3395	May 6, 2021