Hi there, so I have a problem with reading a data string (Hex, 512 Hz) from an EEG-Sensor (TGAM1). It just reads once a couple of data packages and then stops. Of course I put serial.read in the loop. But also, if I read out the incoming data over a serial terminal, like Realterm, I get the same re…

Continuous data stream only when reset button pressed

dermanu May 16, 2018, 6:14pm 4

Sorry, I thought this was a legit question. I'll try it somewhere else.

Topic		Replies	Views
Not another question about serial communication Interfacing w/ Software on the Computer	3	949	May 6, 2021
Reset des Arduino beim Start des Terminal? Deutsch	9	3458	May 6, 2021
Reset Arduino Italiano	10	2317	May 6, 2021
Serial communication problem (pySerial, autoreset) Troubleshooting	4	2706	May 6, 2021
Problemi acquisizione dati seriali Generale	9	2467	May 7, 2021