As per the logic I done in code, the controller output I should get is 0.5. I tested in open loop with multi Meter and got 0.5. But when I connect to load, and getting 0.8V. why this problem comes and how to correct it?

Controller output changes from 0.5 to 0.8, when connecting to load

britto May 28, 2018, 11:39am 5

No Grumpy, it is completely different.

Topic		Replies	Views
mega and output voltage Programming	4	1105	May 5, 2021
microcontroller outputs 3v instead of 5 on HIGH state General Electronics	12	1193	May 6, 2021
voltage drop on output pin(s) Troubleshooting	5	1981	May 6, 2021
Help with voltmeter. General Electronics	6	2470	May 6, 2021
Voltage read circuit with relay on/off Programming	27	8191	May 5, 2021