Some servo test code that uses the serial monitor to increase or decrease the command value being sent to the servo. Don't currently have a servo to test it on, but should work. You should be able to see the servo speed control difference between using the deg. value and microseconds. You could also use it to adjust the servo pot to the desired neutral point value. The code is set up for the right hand to hit the enter key and the left hand hit the a or s key.
// zoomkat 3-28-14 serial servo incremental test code
// using serial monitor type a character (s to increase or a
// to decrease) and enter to change servo position
// use strings like 90x or 1500x for new servo position
// for IDE 1.0.5 and later
// Powering a servo from the arduino usually *DOES NOT WORK*.
#include<Servo.h>
String readString;
Servo myservo;
int pos=1500; //~neutral value for continous rotation servo
//int pos=90;
void setup()
{
myservo.attach(7, 400, 2600); //servo control pin, and range if desired
Serial.begin(9600);
Serial.println("serial servo incremental test code");
Serial.println("type a character (s to increase or a to decrease)");
Serial.println("and enter to change servo position");
Serial.println("use strings like 90x or 1500x for new servo position");
Serial.println();
}
void loop()
{
while (Serial.available()) {
char c = Serial.read(); //gets one byte from serial buffer
readString += c; //makes the string readString
delay(2); //slow looping to allow buffer to fill with next character
}
if (readString.length() >0) {
if(readString.indexOf('x') >0) {
pos = readString.toInt();
}
if(readString =="a"){
(pos=pos-1); //use larger numbers for larger increments
if(pos<0) (pos=0); //prevent negative number
}
if (readString =="s"){
(pos=pos+1);
}
if(pos >= 400) //determine servo write method
{
Serial.println(pos);
myservo.writeMicroseconds(pos);
}
else
{
Serial.println(pos);
myservo.write(pos);
}
}
readString=""; //empty for next input
}