Hi there,
I recently bought this led cube kit from China. I have seen another post on here asking about using an Arduino controller on one of these generic cubes but there was no real end result.
Would there be any way to use the existing PCB and swap out the stc12c5a60s2 for an Arduino (not sure how this would work as the controller uses 40 pins)?
Another thought would be using a Arduino compatible board with the stc12c5a60s2 controller on it (like this maybe?) and then just soldering the pins up.
Hope there is some sort of solution to this, if not I could always just use perfboard or make this for show.
Thanks, Dom.