Hi there! I'm using a Wantai Stepper motor (serial: 57BYGH420) and a microstep driver to control the speed and direction of a wire cutter which is supported by two timing belts. I have written a programme which uses the serial monitor to read either 'd' or 's' for direction or speed respectively. …

Controlling stepper motor with serial monitor - motor stops during each read

system February 26, 2019, 7:14pm 7

Is it possible to use this code also with the A4988 module? Only 2 output pins are enough?

Topic		Replies	Views
Controlling Stepper motor serially Programming	7	3559	May 5, 2021
loop stops Programming	14	2943	May 5, 2021
Need help with Stepper Motor code! Programming	9	1190	May 5, 2021
Control stepper with serial command General Guidance	5	1482	May 5, 2021
How to stop stepper motor through serial monitor command Motors, Mechanics, Power and CNC	4	1377	May 6, 2021