Counter with Arduino UNO

Projects General Guidance
1

Hello comunity,

It's my first time writing in this forum, Actually I'm very new with this Arduino.
And excuse my level english.

My project is this: I need to mount a counter with a display seven segment, on a breadboard, until then everything goes well because it is very simple, the issue is that I need to sync for infrared medium with another breadboard, which will have another display that will simultaneously of the first.

could give me some advice on how to proceed

I have a couple of Arduino UNO

I appreciate any help.

Greetings.

2

If you are wondering how to communicate with infra-red this Thread may help.

...R

3

WHILE UPLOADING PROGRAM SHOWING ERRORS
Arduino: 1.5.8 (Windows 7), Board: "Arduino Uno"

Sketch uses 1,068 bytes (3%) of program storage space. Maximum is 32,256 bytes.

Global variables use 11 bytes (0%) of dynamic memory, leaving 2,037 bytes for local variables. Maximum is 2,048 bytes.

avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x01
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0x01
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 3 of 10: not in sync: resp=0x01
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 4 of 10: not in sync: resp=0x01
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 5 of 10: not in sync: resp=0x01
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 6 of 10: not in sync: resp=0x01
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 7 of 10: not in sync: resp=0x01
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 8 of 10: not in sync: resp=0x01
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 9 of 10: not in sync: resp=0x01
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 10 of 10: not in sync: resp=0x01
Problem uploading to board. See http://www.arduino.cc/en/Guide/Troubleshooting#upload for suggestions.

This report would have more information with
"Show verbose output during compilation"
enabled in File > Preferences.

PLZ REPLY

4

asaini7788:
WHILE UPLOADING PROGRAM SHOWING ERRORS
Arduino: 1.5.8 (Windows 7), Board: "Arduino Uno"

Why are you asking this question in this Thread?

...R

5

Robin2:
If you are wondering how to communicate with infra-red this Thread may help.

...R

thank you very much
helped me a lot