CPR Device using Arduino

Projects General Guidance
1

Hi, I am making a project for a CPR Device using Arduino UNO.

I want to connect a Piezo Electric Shock at the shoulder of the mannequin and if it sensed a tapping on shoulder, a green LED light will light up. Another one is connecting a Force Sensitive Resistor in the Chest that will give a written feedback in a LED Display if the compression is too deep, too low or good also with the light feedback, green for good compression and red for not. Lastly, connecting it in a flow sensor that detects the air pressure give during a mouth to mouth resuscitation. The Flow sensor and Force sensitive resistor will be programmed depends on the category of a patient whether it is adult or young.

Will it be possible? I actually need a programmer for it. Kindly message me if your interested. Thank you

2

Are you building something, or asking for someone to build it for you?

3
  1. Touch sensor, LED, resistor to sense "tap"
  2. Air bladder with sphygmomanometer or pressure transducer to measure compression.
  3. Gyro to sense head tilt/jaw lift
  4. Miniature vibration motors for tactile feedback from 1, 2 and 3.
4

Hi, I actually want a consultation if this is feasible. I also need someone to program it for me, I am not familiar with arduino programming.

5

Hi,
Is this a school/college/university project?

Thanks.. Tom... :smiley: :+1: :coffee: :australia:

6

This topic was automatically closed 180 days after the last reply. New replies are no longer allowed.