DC motor driver L6203

Hey,
I got L6203 motor driver and I tried to set it up so that Arduino would control its speed using random info. I looked at the online tutorials and still couldn't make motor even running, not sure if I connected pins properly as tutorials use different drivers. anyone hae any clue about it?
thanks.

A picture of your current, not working set up, would be nice.

hey, thnx for reply, here is all the info.

I tried to upload the pics but didn't manage, so I put them into a blog, please check out
http://bigkelectro.blogspot.com/

I found the code and just erased what I should not need. I plan to give it a random speed in 3 minute sequences so if have any suggestions you're welcome

int enablePin = 9;  //Motor's enable pin
int dPin_1 = 6;// Digital Pin to turn the motor on/off
int dPin_2 = 7;

 
void setup()
{
pinMode(enablePin, OUTPUT);
pinMode(dPin_1, OUTPUT);
pinMode(dPin_2, OUTPUT);

}
 
void loop()
{
digitalWrite(enablePin, HIGH);
digitalWrite(dPin_1, HIGH); //turn on the motor
digitalWrite(dPin_2, LOW);
 
delay(3000); //delay for 3 seconds
 
}