That can handle PWM signal control, changing of motor direction. I am talking about large DC motor say 48V and 6-7 Amperes.
There is no point in starting a new thread. Please continue the thread you already have going.
However, "say 6-7 Amperes" is not good enough. You must know the motor stall current.
Thread locked.
Would it help if cross-posters got an automatic forum timeout?
Aren't most cross-posters relatively new, with 5 minute or 10 minute limit between posts already?
This one's been a member since October 2014.
Only 23 posts tho - I thought the time out was removed after 100 posts. Is OP grandfathered in perhaps?