Décibel avec ICS43434 avec ESP32

International Français
67

Il n'y a que lui qui à fait un programme comme ça car moi je veux quelque chose de simple
en gros si - 80 db affiche une image et si plus une autre image et je veux l'intégrer dans mon programme .
Avec ce programme il n'y a pas moyen d'obtenir les db ? même approximatif

#include "driver/i2s.h"
const i2s_port_t I2S_PORT = I2S_NUM_0;

void setup() {
  Serial.begin(115200);
  esp_err_t err;

  // The I2S config as per the example
  const i2s_config_t i2s_config = {
      .mode = i2s_mode_t(I2S_MODE_MASTER | I2S_MODE_RX), // Receive, not transfer
      .sample_rate = 16000,                         // 16KHz
      .bits_per_sample = I2S_BITS_PER_SAMPLE_32BIT, // could only get it to work with 32bits
      .channel_format = I2S_CHANNEL_FMT_ONLY_LEFT, // use left channel
      .communication_format = i2s_comm_format_t(I2S_COMM_FORMAT_I2S | I2S_COMM_FORMAT_I2S_MSB),
      .intr_alloc_flags = ESP_INTR_FLAG_LEVEL1,     // Interrupt level 1
      .dma_buf_count = 4,                           // number of buffers
      .dma_buf_len = 8                              // 8 samples per buffer (minimum)
  };

  // The pin config as per the setup
  const i2s_pin_config_t pin_config = {
      .bck_io_num = 23,   // Serial Clock (SCK)
      .ws_io_num = 18,    // Word Select (WS)
      .data_out_num = I2S_PIN_NO_CHANGE, // not used (only for speakers)
      .data_in_num = 19   // Serial Data (SD)
  };

  // Configuring the I2S driver and pins.
  // This function must be called before any I2S driver read/write operations.
  err = i2s_driver_install(I2S_PORT, &i2s_config, 0, NULL);
  if (err != ESP_OK) {
    Serial.printf("Failed installing driver: %d\n", err);
    while (true);
  }
  err = i2s_set_pin(I2S_PORT, &pin_config);
  if (err != ESP_OK) {
    Serial.printf("Failed setting pin: %d\n", err);
    while (true);
  }
  Serial.println("I2S driver installed.");
}

void loop() {
  // Read a single sample and log it for the Serial Plotter.
  int32_t sample = 0;
  int bytes_read = i2s_pop_sample(I2S_PORT, (char *)&sample, portMAX_DELAY); // no timeout
  if (bytes_read > 0) {
    Serial.println(sample);
  }
}