Hey There, I have an IR receiver on pin 5.5v, GND, and pin 7. In my effort to make the circuit as small as possible I accidentally made the three pins of the IR receiver touch another wire all together, I saw a sparkle... Led 13 still blinks fine when I press the hardware reset button. I can't see …

Did I just fry my Arduino Uno?

system September 8, 2012, 4:53pm 4

Check for a short circuit the arduino's turns off on a short hope this helps
Ewan

Topic		Replies	Views
uh oh i think my arduino is gone Troubleshooting	1	900	May 6, 2021
Did I fry my Arduino??? IDE 1.x	3	1141	May 5, 2021
avrdude: stk500_recv(): programmer is not respondi Troubleshooting	4	1051	May 6, 2021
problema avrdude: stk500_recv(): programmer is not Italiano	5	1171	May 6, 2021
avrdude: stk500_recv(): programmer is not responding IDE 1.x	9	8135	May 5, 2021