DigiSpark Pro ATtiny167 "Device not recognized" what am I missing

Other Hardware 3rd Party Boards
1

Hi,
I'm frustrated I feel like I am 90% there but my computer will not recognize the ATtiny167. Here i9s the list of things I have completed/tried using Windows 10 and Arduino 1.8.6;

  1. Installed Driver USB Bootloader is complete
  2. Device Management I see the device
  3. Arduino Sketch select 16.5 MHz board in parameters
  4. Led on the board flashes sound beeps and stops flashing
  5. "Device not recognized"
  6. I have rebooted many times. I deleted everything and started over again with same
    results
  7. Used a 3rd party software to look at my USB ports it see the device
  8. I have tried more than one device as well

I'm stuck at this point. I've tried running example programs however the device is not recognized.

Any suggestions?

2

It sounds like you're using the Digispark Pro with the t167?

That is a very different matter than just using the t167 straight up.

Please confirm?

3

Yes, I am using the Digispark Pro ATtiny167.

FOYR2PSJYSZ6URO.LARGE.jpg
FOYR2PSJYSZ6URO.LARGE.jpg931×700 86.5 KB

4

Hi, I went back and carefully read through the instructions again and changed it to 16MHz the flashing program now downloads to the ATtiny167. So I am able to change the flashing rate. However, I am not able to get rid of the error message with Windows 10 saying the USB Device is not recognized. Any suggestions?

Here is the link to the instructions I am directed to use. I also updated the Topic for future reference.

https://digistump.com/wiki/digispark/tutorials/connectingpro