Hello, I'm using voltage division to read the voltage of a 12 volt battery. This gives me a voltage between 3 and 4 volts to an analog pin. But I'm running out of analog pins. I'd like to use a digital pin instead to trigger at say 3.7 volts. Is there a way to set this level using say resistors i…

Digital pin trigger level

Jonasforssell September 3, 2012, 8:38pm 8

Ok, thanks!

Topic		Replies	Views
measuring battery voltage Interfacing	3	1504	May 6, 2021
How to sense 12v or Higher with Arduino? Interfacing	12	41194	May 6, 2021
How does digitalRead() determine if pin is HIGH or LOW? General Guidance	8	21181	May 5, 2021
Turn on an LED when certain voltage has been reached? General Electronics	11	11009	May 6, 2021
help: need to read current voltage value Interfacing	11	3263	May 6, 2021