Diymall 0.96" Inch Yellow and Blue I2c IIC Serial 128x64 Oled LCD LED Display Mo

Anyone have a basic example sketch for this utilizing the Adafruit library

This code should work, however my Diymall .96 Yellow and Blue OLED LCD did not come with a backlight that worked. The address in the WireTransmission line might be different than what is below.

//#include <Adafruit_GFX.h>
#include <Wire.h>
//#include <LiquidCrystal.h>
byte val = 1;
int ledPin=13;
void setup() {
  
 // lcd.display();
  Wire.begin();
  pinMode(ledPin,OUTPUT);

}

void loop() {
  digitalWrite(ledPin,HIGH);
  Wire.beginTransmission(0x7B);
  delay(500);
  Wire.write(val);
  Wire.endTransmission();
  delay(500);
  digitalWrite(ledPin,LOW);

}

I have the same type of display but from a different manufacturer. It's still the I2C based though. Perhaps my two examples will help. They are explained in a short YouTube video.

  1. basic usage https://www.youtube.com/watch?v=7ph5ov56cfg

  2. an oscilloscope https://www.youtube.com/watch?v=jYaWjMUfkMg

Thank you.