Just getting back into Arduino and puzzling over this probably basic point. In my main loop I have an if. Its condition is met and an LED switched on, followed by a delay of 4 seconds, then the end of the if and the loop. But the LED (and its 220 ohm resistor) appears to be getting only about 2.5V.…

have you set pinMode? show your code.

Does a delay inside an if() pause loop?

anon35827816 August 31, 2021, 4:42pm 8

I know the feeling Happens to all of us at some point. Or several points...

1 Like

Topic		Replies	Views
Nuances of shetch Code Programming	3	878	May 5, 2021
Trouble with if command Troubleshooting	9	2856	May 6, 2021
Trouble getting an LED to blink within an if statement Programming	4	1154	May 5, 2021
code line placement question Programming	10	1926	May 5, 2021
Led che non si spegne Generale	8	1136	May 7, 2021